Hiseeu AHDNH 1080N 8CH CCTV DVR

CoyoteNB

vlc alexa ip cam

CoyoteNB

HI,
sorry this board software is a bit confusing
i got the system running by single cam via VLC and Anycam
now i try to get it running on our Alexa Show 5 …
As DVR unit :

as stream url i got rtsp://:@192.168.1.222/user=&password=&channel=2&stream=1.sdp

the monocle skill is installed and i got the setup done…

I can see the cams in the Device list
when i cal out Alexa show me Shop …
it say 1. Waiting om Shop
then
“I’m quit not sure what went wrong”

[
  {
    "timestamp": "2020-12-30T01:51:54.400Z",
    "request": "InitializeCameraStreams",
    "response": [
      {
        "uri": "rtsp://192.168.1.222/user=&password=&channel=7&stream=1.sdp",
        "proxy": "rtsp://proxy.monoclecam.com:443/70ff1e7c-30c3-4b2a-9f7a-742f278357d2",
        "resolution": {
          "width": "352",
          "height": "240"
        },
        "authorizationType": "NONE",
        "videoCodec": "H264",
        "audioCodec": "AAC",
        "protocol": "RTSP"
      }
    ]
  },

thats what the log shows up.

i read over the Forum and found some point that i try {adjust resolution etc}

now Im here with a lots of ???

CoyoteNB

hi me again
ok ok i figure out that the show 5 need the gateway …
installed
but still nothing?!

pls any hinds

CoyoteNB

thx for the great help here problem solved

CoyoteNB

@CoyoteNB said in Hiseeu AHDNH 1080N 8CH CCTV DVR:

thx for the great help here problem solved

or not it works now with the 2 ptz cams but still not with the unit
on the ptz ones it was the audio settings and @proxy not @tunnel
but with the mainunit still same probs