Errors - Errors Everywhere (But with a successful feed)!



  • The Image below should, hopefully, show enough information as to what’s happening but basically the Gateway is running fine on my Raspberry Pi and I can see the image from the cameras I’ve set up, but I’m getting these errors when I run a TAIL.
    Errors.jpg

    These are Hikvision cameras and I have the following cameras set up. The Error was when I saw the Drive Camera (I’m sure it’ll be there for the other camera too)…
    As an aside, the camera feed only lasts between 35 and 45 seconds before it buffers and stops.
    Cameras.jpg

    Help! How to I stop these errors?


Log in to reply