So are UniFi cameras off the support list or is it my gen 3 Show 5?
-
- UniFi G4 Instant camera
- Using RTSP, not RTSPS
- Validated stream URL using VLC
- Gateway setup, initializing clean, W10
- Port 443 available
- mproxy.io DNS resolving to gateway IP
- Monocle skill enabled
- Camera set up, h.264, AAC 1280x720, @tunnel
- Camera discovered as a new device
- Echo Show 5 gen 3 voice command reaches the gateway as shown by the log, but only shows the initial request, no actual connection details
- @noaudio and @proxy have no effect
- Show is on a network that can access the gateway and the camera, not cross-VLAN
So, with all the troubleshooting topics covered, where are we with Ubiquiti and gen 3 Echo Show 5s?