Hiseeu AHDNH 1080N 8CH CCTV DVR



  • vlc alexa ip cam



  • HI,
    sorry this board software is a bit confusing
    i got the system running by single cam via VLC and Anycam
    now i try to get it running on our Alexa Show 5 …
    As DVR unit :
    dvr.jpg

    as stream url i got rtsp://:@192.168.1.222/user=&password=&channel=2&stream=1.sdp

    vlc.jpg

    the monocle skill is installed and i got the setup done…

    mono.jpg

    I can see the cams in the Device list
    when i cal out Alexa show me Shop …
    it say 1. Waiting om Shop
    then
    “I’m quit not sure what went wrong”

    [
      {
        "timestamp": "2020-12-30T01:51:54.400Z",
        "request": "InitializeCameraStreams",
        "response": [
          {
            "uri": "rtsp://192.168.1.222/user=&password=&channel=7&stream=1.sdp",
            "proxy": "rtsp://proxy.monoclecam.com:443/70ff1e7c-30c3-4b2a-9f7a-742f278357d2",
            "resolution": {
              "width": "352",
              "height": "240"
            },
            "authorizationType": "NONE",
            "videoCodec": "H264",
            "audioCodec": "AAC",
            "protocol": "RTSP"
          }
        ]
      },
    

    thats what the log shows up.

    i read over the Forum and found some point that i try {adjust resolution etc}

    now Im here with a lots of ???



  • hi me again
    ok ok i figure out that the show 5 need the gateway …
    installed
    but still nothing?!

    log.jpg
    pls any hinds



  • thx for the great help here problem solved



  • @CoyoteNB said in Hiseeu AHDNH 1080N 8CH CCTV DVR:

    thx for the great help here problem solved

    or not it works now with the 2 ptz cams but still not with the unit
    on the ptz ones it was the audio settings and @proxy not @tunnel
    but with the mainunit still same probs


Log in to reply